System information

52
RTS Threshold(2): Set the RTS threshold of wireless radio. Do not modify
default value if you don’t know what it is, default
value is 2347.
Beacon Interval(3): Set the beacon interval of wireless radio. Do not
modify default value if you don’t know what it is,
default value is 100.
DTIM Period(4): Set the DTIM period of wireless radio. Do not modify
default value if you don’t know what it is, default
value is 3.
Data Rate(5): Set the wireless data transfer rate to a certain value.
Since most of wireless devices will negotiate with each
other and pick a proper data transfer rate automatically,
it’s not necessary to change this value unless you
know what will happen after modification.
N Data Rate(6): Same as above, but only for 802.11n clients.
Channel Width(7): Set channel width of wireless radio. Do not modify
default value if you don’t know what it is, default
setting is ‘Auto 20/40 MHz’.
Preamble Type(8): Set the type of preamble, do not modify default value
if you don’t know what it is, default setting is ‘Short
Preamble’.
Broadcast ESSID(9): Decide if the wireless Outdoor Wireless-N Smart
Repeater will broadcast its own ESSID or not. You can
hide the ESSID of your wireless Outdoor Wireless-N
Smart Repeater (set the option to ‘Disable’), so only
those people who know the ESSID of your wireless
Outdoor Wireless-N Smart Repeater can get
connected.
CTS Protect(10): Enabling this setting will reduce the chance of radio
signal collisions between 802.11b and 802.11g/n