User Manual

9 10
PRE-ZEROING
Pre-zero sighting can be done either visually or with a bore sighting collimator. If a bore sighting
collimator is not available, it is recommended to pre-zero visually.
1. With the rearm in a steady rest position, open the action of the rearm and look along the
bore to a predetermined target (at approximately 50 yards).
2. Scopes tted with an adjustable objective or side focus should be adjusted to the 50 yard
position. Set a variable power scope to mid-power.
3. Remove the caps from the windage and elevation turrets. Adjust the windage and elevation
adjusters to position the reticle on the center of the target.
4. For windage adjustment, turn the windage adjustment turret clockwise to move the point of
impact left and counter clockwise to move the point of impact right. In the same manner, adjust
the elevation by turning the elevation adjustment clockwise to lower the point of impact and
counter clockwise to raise the point of impact.
Note: When using windage adjustable rings, make major windage correction with them. In certain
shooting situations such as close range air gunning when special elevation adjustable rings are not
available, the rings may have to be shimmed. Only nal precision adjustment should be made with
the scopes adjustment turrets.
ZEROING WITH LIVE AMMUNITION
Warning: All shooting should be carried out at an approved range or other safe area. Eye and ear
protection is recommended.