User Manual
7 8
Therefore at different ranges, each click of adjustment changes: 50 yards = 1/8” (50m = 4mm), 100
yards = 1/4” (100m = 7mm), 200 yards = 1/2” (200m = 15mm), 300 yards = 3/4” (300m = 22mm).
TURRET ADJUSTMENT - SIDEWINDER 30 SF
1. Before adjusting the turrets, you must rst unlock them; this is achieved by pulling them
outwards. They will now click when rotated.
2. The turrets can then be adjusted until they are on zero. To lock the
turrets, simply push them back down.
3. When a satisfactory zero is achieved, the turrets can be reset. To do
this, loosen the hex screw with the turret in the down and locked
position, rotate the turret cover to the zero position, and then re-
tighten the hex screw.
TURRET ADJUSTMENT - AIRMAX 30 SF
1. To unlock the turrets, rotate the lock (located on the top of the
turrets) counter-clockwise. Rotate the lock clockwise to lock the
turrets into position.
2. The turrets can be reset once the riescope has been zeroed to make
future adjustment easier. Loosen the three screws on the selected
turret using the allen key provided. The turret can now be rotated to
zero without making any adjustments.
3. When the turret is in position, use the allen key to re-tighten the screws (be careful not to over
tighten).