Owner's manual

Wrench Maintenance
Wrench Maintenance
G2
32 Maintenance & Repair
Grease Once per Week, Minimum
Tools Required
Grease gun
Initial Steps
1. Make sure the HawkJaw is off the
drill pipe connection and in the rest
position on the derrick.
2. Shut down the Hydraulic power
unit.
3. Press the Grip button repeatedly to
bleed hydraulic pressure.
4. Disconnect the Air power supply.
5. Push in the “E” stop.
6. Assume that there is still a load on
every actuator. Proceed with caution.
Grip Cylinder Pivot Points
1.  PumpgreasettingsG1-G2 on
each Grip Cylinder.
Torque Cylinder Pivot Points
1.  PumpgreasettingsT1-T3.
Tilt Cylinder Pivot Points
1.  PumpgreasettingsTC1-TC2.
NOTE
Consistent lubrication of the cylinder
pivot points increases performance and
component life.
G1
T1 T2 T3
TC2