Datasheet

ManualsBrandsHavis ManualsMobile PhonesC-VS-1800-CAPR-1

C-VS-1800-CAPR-1_INST_1-12

C-VS-1800-CAPR-1

(Assembly)

INSTALL INSTRUCTIONS C-VS-1800-CAPR-1

2011- 2013 Chevy Caprice (9C1 Police Package)

VEHICLE SPECIFIC CONSOLE

With 18” inches Equipment space

TOOLS NEEDED:

Phillips Screw Driver

Socket set (Standard & Metric)

Wire Cutters Wire Crimping tool

7/16 wrench T-20 Torx Bit

QTY DESCRIPTION PART #

1 Main Console Housing only CM004588

1 Accessory Box / mount kit includes the following:

1 Accessory box housing CM004523

1 15” notched extrusion CM002432-17

1 Front cover plate with pole cutout CM004526

1 Rear cover plate with pole cutout CM004527

1 Floor bracket (driver side) CM004522-2

1 Floor bracket (passenger side) CM004522-1

2 Rear bracket CM004598

2 12 volt socket CM216560

1 Hardware kit C-HK-191

CM004526 and CM004527

Front and rear cover plate with pole cutout

CM004588

Main Console Housing

CM004523

Accessory box housing

Mount brackets not shown

ALWAYS!

* Read all Instructions before installing any Havis, Inc. products.

* Use Hardware included with install kit

CM002432-17

15” notched extrusion

CM216560

12 volt sockets

Summary of content (4 pages)

PAGE 1
INSTALL INSTRUCTIONS C-VS-1800-CAPR-1 2011- 2013 Chevy Caprice (9C1 Police Package) VEHICLE SPECIFIC CONSOLE With 18” inches Equipment space TOOLS NEEDED: Phillips Screw Driver Socket set (Standard & Metric) QTY 1 1 1 1 1 1 1 1 2 2 1 DESCRIPTION Main Console Housing only Accessory Box / mount kit Accessory box housing 15” notched extrusion Front cover plate with pole cutout Rear cover plate with pole cutout Floor bracket (driver side) Floor bracket (passenger side) Rear bracket 12 volt socket Hardware kit
PAGE 2
View of O.E.M. dash prior to C-VS-1800-CAPR-1 console installation. Use 6 mm x 30 mm bolt, flat washer and 7/16” spacer to attach rear bracket to OEM floor mounts. Attach passenger side bracket (CM004522-1) to transmission hump using OEM hardware. (15 mm socket) Note: Newer version bracket has extension towards front and has three (3) holes for attaching to the extrusion. Remove plastic fasteners and remove center O.E.M. plastic cover next to shifter. Ready for console installation.
PAGE 3
Attach extrusion to brackets with 1/4" x 1/2” hex bolts and flat washers. (Driver side shown) End of extrusion should line up with the end of bracket. (Passenger side shown) Extrusion platform is now in place. Push down and tighten hardware. Wire harnesses can be routed through lower dash as shown. Assemble console housing and accessory box with 1/4” x 1/2” carriage bolts and serrated nuts. Place console assembly into position and attach to brackets with 1/4"x 3/4" hex bolts and flat washers.
PAGE 4
Run all wiring including 12 volt sockets. This accessory mount has a knockout in forward side for wiring access if desired. Optional C-HDM-208 computer mount bolts to extrusion in location as shown. Filler plates with cutouts included. Mount optional cup holder or computer mount.