manual

C-VS-1600-EXPL-1_INST_7-12.docx
Adjust position and tighten console
housing to brackets. (7/16 wrench)
This photo shows O.E.M. rear controls
mounted in console. Four (4) 8/32 x 1/2”
screws provided. Note: It is not necessary
to use the controls if not desired.
Before inserting cup holder, run necessary
wiring and wire tie as needed. Make sure
wiring is not stressed or that it does not
interfere with shifter mechanism.
View of completed installation with
UT-X Laptop mount.
New console housing prior to
control head installation.
Console includes mounting
provisions for side mounted
C-HDM-204 or C-TCB-7 computer
mount brackets.
View of completed installation in
2013 Interceptor Utility with
Optional # CM005159 Top /
Forward Trim Bezel
Note: As of 10//4/13, there is a new
console model C-VS-2400-INUT-1
available for the Interceptor Utility
that includes this configuration.
View of completed installation in
2013 Interceptor Utility
with Optional
# CM005159 Top / Forward Trim
Bezel,
C-CUP2-I cup holder and C-ARM-
103 arm rest.
View of completed installation
View of completed installation with
Laptop computer.