manual

C-VS-1600-EXPL-1_INST_7-12.docx
Attach # CM004246 front shifter
platform to hump bracket with four
(4) 1/4 x 3/4 Hex head bolts, lock
washers and flat washers.
(7/16 wrench)
Attach previously removed sensor
onto # CM004239 rear mount
bracket studs and 1/4 serrated nuts.
Plugs facing rear of vehicle.
(7/16 wrench)
Remove console housing.
Detach O.E.M. harness from
console housing. To be reused.
A 90° scribe works well for
popping out harness clips.
Console harness shown removed.
Note: Small harness for cup holder
lights does not need to be removed.
Remove HVAC controls from rear
console housing if you desire to reuse
it in the new console. The plug for
this can remain disconnected if
controls are not used.
Remove O.E.M. forward and
middle brackets from transmission
hump. Save hardware.
(8mm socket)
With battery disconnected
,
temporarily unplug harnesses from
OEM sensor and detach two (2)
harness clips from transmission hump.
Mount new # CM004244 front
hump bracket to transmission
hump with O.E.M screws
previously removed.
(8mm socket)
Route harnesses over bracket
and reconnect to sensor.