manual

C-VS-1600-EXPL-1_INST_7-12.docx
Shifter assembly is now removed
and will be reused later.
Using a flat screwdriver,
carefull
y
pop off the shifter cable end from
the linkage stud.
Pop toward driver side.
Passenger side / rear bolt shown. Passenger side / side bolt shown.
Detach carpet from side of console.
Unplug main harness from console
base at passenger side front.
Remove sensor from bottom of
storage pocket. To be reused later.
(10mm socket)
Carefully
unclip shifter cable from
shifter mount assembly. This is done
by pushing the two white tabs forward
and sliding cable towards driver side.
Both tabs need to be done at the same
time. Small screw drivers can be used
for this.
Unplug harness from shifter
assembly. Remove four (4) bolts
holding shifter assembly to plastic
console housing. (8mm socket)
Total of eight (8) bolts holding the
main plastic console housing to
floor must now be removed. Two
(2) forward driver side bolts
shown. (10mm socket)