manual

C-VS-0809-CHGR-1_INST_4-11
Remove O.E.M. plastic center
console
Remove Ignition proximity sensor /
antenna from rear underside of
O.E.M. console.
(Phillips Screwdriver)
** SEE NOTE BELOW **
Remove sensor and 12 volt socket
wire harness assembly from under
side of O.E.M. console.
Pop out “AUX” socket from center
of O.E.M console.
O.E.M. console prior to
C-VS-0809-CHGR-1 console
installation.
Remove forward O.E.M console
plastic cover and remove two (2)
nuts from front floor bracket.
Nuts to be reused. (10mm)
Remove bolts that hold underside
of extrusion to rear floor bracket.
(7/16 wrench)
Remove rear floor bracket bolts
and center console bolt. (10mm)
Carefully place console assembly
between seats and onto front O.E.M.
floor studs.
On 2011 Charger, attach Ignition
proximity sensor /antenna to
transmission hump with Velcro.
NOTE: 2012 and newer cars include
an O.E.M. bracket with this sensor
already relocated. Velcro mounting
will not be needed
Plug O.E.M. wire harness back
onto original connectors.
Passenger side