manual

INSTALL INSTRUCTIONS C-TSM-CHGR-X-1

TRUNK SIDE MOUNT FOR 2011-2013 DODGE CHARGER

X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE

TOOLS REQUIRED:

Phillips Screwdriver

Jig Saw

Powered drill with 5/32” drill bit

HARDWARE:

QTY DESCRIPTION PART #

5 #10 x ¾” Sheet metal screws GSM33195

Always!

 Read all instructions before installing any Havis, Inc. products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use hardware provided with install kit

C-TSM-CHGR-P-1 shown

Trunk Side Mount

(Passenger Side)

NOTE:

This instruction

shows the passenger side

installation. The Drivers side

will install the same way.

PAGE 1
INSTALL INSTRUCTIONS C-TSM-CHGR-X-1 TRUNK SIDE MOUNT FOR 2011-2013 DODGE CHARGER X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE TOOLS REQUIRED: Phillips Screwdriver Jig Saw Powered drill with 5/32” drill bit HARDWARE: QTY DESCRIPTION 5 #10 x ¾” Sheet metal screws PART # GSM33195 Always! Read all instructions before installing any Havis, Inc. products. Check for obstructions (Wire, brake lines, fuel tank, etc.
PAGE 2
View of passenger side trunk area prior to installation. Remove fender liner. Run wiring as needed for emergency equipment. Remove side cargo hook. Mount screw to be reused later (Phillips screwdriver) Unclip and move wiring at side floor area. Make sure it is repositioned so it will not get damaged. Replace fender liner. Make sure door has clearance at rear trunk trim panel. With Trunk Side Mount in position, drill three 5/32”” holes into floor.
PAGE 3
Drill 5/32”holes at upper bracket (next to OEM screw) and attach with # 10 x 3/4” Sheet metal screws Mount and wire equipment on inside door panel. Finished Passenger-Side Mount shown with full width trunk tray Finished C-TSM-CHGR-P-1 (Passenger Side Trunk Side Mount) Shown with Full Size Spare Tire. NOTE: If your vehicle has the small donut spare tire, the flip up trunk liner should just clear the Trunk Side Mount.