manual

C-TMW-GMC-02_INST_3-10
2
Slide seat forward and r
emove OEM
trim panel covering
rear inner seat bolts on driver and passenger sides.
Remove seat bolt studs. (11 mm socket required)
Remove OEM trim panel covering front inner
seat bolts on driver and passenger sides.
Remove seat bolt nuts. (15 mm socket required.)
Loosely pre assemble front hump bracket
with 1/4” x 3/4” bolts and flat washers, then
position it under the OEM front seat brackets.
Loosely
pre assemble rear hump bracket
with
1/4” x 3/4” bolts and flat washers, then
position it under the OEM rear seat brackets.
Determine the desired position of
the
Tunnel
plate
and mark location with a pencil on the hump
brackets. Remove the front and rear hump bracket
cross supports.
Insert 1/4” x 3/4” bolts into the bottom of Tunnel
plate
.
Line up Tunnel plate on cross supports where previously marked.
Use 1/4” serrated nuts to attach.
Reattach Tunnel with cross supports back onto seat brackets.