Installation instructions



 C‐TM‐SEATMT_INST_7‐10



INSTALLATION INSTRUCTIONS

C-TM-SEATMT

Universal Seat Mount Platform for Laptop Computers

TOOLS REQUIRED:

Ratchet Wrench and Socket Set Phillips Screw driver

7/16” Open End Wrench



PARTS and MOUNTING HARDWARE:

QTY DESCRIPTION PART #

1 Seat Mount Backing Plate CM002510

1 Ratchet Strap with Hooks GSM20085

Allotherhardwarecomesalread

attachedtoseatmountassembl

orwithothero

tional

arts.

Always!

¾ ReadallinstructionsbeforeinstallinganyHavisInc,products.

¾ Useonlyhardwareprovidedwithinstallkit.

¾ Forproductsupport,visittheInstallInstructionsSectionofourwebsiteat

http://havis.com/Installation/Installation.html,emailtechnicalsupport@havis.comorcall1‐800‐

524‐9900andaskfortechnicalsupport.

C-TM-SEATMT

ASSEMBLY DRAWING

CM002510 Seat Mount Backing Plate

GSM20085 Ratchet Strap with Hooks

PAGE 1
INSTALLATION INSTRUCTIONS C-TM-SEATMT Universal Seat Mount Platform for Laptop Computers TOOLS REQUIRED: Ratchet Wrench and Socket Set 7/16” Open End Wrench Phillips Screw driver PARTS and MOUNTING HARDWARE: QTY DESCRIPTION PART # 1 1 CM002510 GSM20085 Seat Mount Backing Plate Ratchet Strap with Hooks All other hardware comes already attached to seat mount assembly or with other optional parts.
PAGE 2
Assemble Strap with Hooks and Backing plate as shown in photo and / or drawing. Ratchet on passenger side works best. Before attaching additional parts, place the main assembly on the seat top. Adjust the rear plate so it is against the seat back. Adjust the forward plate so it wraps closely over the front of seat pad. Bolt LPS‐XXX power supply to the bottom of Docking Station and attach Dock to seat mount assembly with C‐MD‐202 Tilt Swivel. Parts sold separately.
PAGE 3
Position backing plate so it will not pull back through the front of seat. Attach both hooks underneath the seat to a sturdy location. Do NOT attach to moving parts or wires. Pull strap slack through ratchet mechanism and tighten the ratchet so the platform is firmly attached to seat. Adjust brackets to position the computer in the desired location. Plug power cable into the 12 volt power source. This platform can accommodate an optional printer mount.