Datasheet

C-SM_INST_9-10
4. ATTACH PENTEX PRINTER BRACKET: (See Figure #4)
• Printer bracket attaches to front side of console.
• When mounted properly, printer housing will slide toward passenger side seat.
• Attach to Angled Heavy Duty console using supplied screws and Keps nuts.
5. MOUNT CONSOLE TO TUNNEL PLATE:
• Slide ¼-20 x ¾” bolts into slots of Tunnel Plate.
• Place Angled Heavy Duty console over ¼” bolts.
• Position console and attach to Tunnel using ¼-20 serrated nuts.
6. ATTACH CONSOLE EXTENSION: (C-SM-600, 800, 1200 see Figure 5)
• With Angled Heavy Duty console attached to Tunnel, position and attach 6” console
extension. **A spare plastic end cap is provided in case you choose not to attach
consoles together. Simply peel and stick to console end plate if desired.
• Slide (2) ¼-20 x ¾” hex head bolts into slots of Tunnel Plate.
• Place console extension and bolt down using ¼-20 serrated nuts.
• Connect opposite end-to-end plate of Angled Heavy Duty housing. (Slot to slot).
Adjust height as desired.
• Wire and install control heads and accessories.
Mounts to
Angled Heavy
Duty console
Mounting
Hardware
Figure #4
Figure #5
Tunnel Plate
Hardware
A spare plastic end
cap is provided in
case you choose not
to attach consoles
together