Van Permanent Rear Step Installation Instructions

INSTALL INSTRUCTIONS KK-S-ST-RP

PERMANENT REAR STEP

2002-2008 SPRINTER VAN

TOOLS REQUIRED:

Ratcheting wrench

Standard socket set

Open-end wrench set

Power drill

Drill bit set

HARDWARE:

QTY DESCRIPTION PART #

8 ½-13 x 1 ½” Hex head bolt GSM33050

12 ½-13 x 4” Hex head bolt GSM33056

40 ½” Flat washer GSM31009

8 ½” Lock washer GSM31030

8 ½-13 Hex nut GSM30011

12 ½-13 Nylock nut GSM30020

4 ¼” x ¾” Lag bolt GSM33060-1

SUB ASSEMBLY:

1. Confirm receipt of all parts.

2. Differentiate all components and hardware in kit.

Channel bracket(s)

(See note below)

Note: Three Channel

brackets will come with Rear Step

kit, one short and two long. Use two long brackets for

vehicles with single rear wheels & one short bracket

and one long on vehicles with dual rear wheels.

(2 per

side)

Upper

mounting brackets

Bumper mounting

“L” bracket

Step assembly

PAGE 1
INSTALL INSTRUCTIONS KK-S-ST-RP PERMANENT REAR STEP 2002-2008 SPRINTER VAN TOOLS REQUIRED: Ratcheting wrench Standard socket set Open-end wrench set Power drill Drill bit set HARDWARE: QTY DESCRIPTION 8 ½-13 x 1 ½” Hex head bolt 12 ½-13 x 4” Hex head bolt 40 ½” Flat washer 8 ½” Lock washer 8 ½-13 Hex nut 12 ½-13 Nylock nut 4 ¼” x ¾” Lag bolt PART # GSM33050 GSM33056 GSM31009 GSM31030 GSM30011 GSM30020 GSM33060-1 SUB ASSEMBLY: 1. Confirm receipt of all parts. 2.
PAGE 2
INSTALLATION: 1. MOUNT PERMANENT REAR STEP: • Locate (4) ½” holes located on each side of the vehicle frame rails. • Bolt the Upper mounting brackets (2 per-side) using the ½” holes and (8) ½-13 x 4” Hex bolts, washers, and Nylock nuts. If also mounting Kwik Kit, be sure to mount to doorframe brackets at this time. See photo below.