- Hacis-Shields 1997-2007 Dodge Dakota Telescoping Computer Base Install Instructions

INSTALL INSTRUCTIONS C-TCB-28

1997-2007 DODGE DAKOTA

TELESCOPING COMPUTER BASE

TOOLS REQUIRED:

Ratcheting wrench

3/8” Metric Socket Set

T-20 torx bit

3/8” Standard Socket Set

Combination wrench set

Powered Drill

Drill Bit set

HARDWARE:

QTY DESCRIPTION PART #

4 ¼” x 1” Hex head lag bolt GSM33060

1 5/16” Flat Washer GSM31006

1 5/16” Nylock Nut GSM30017

1 “Z” Bracket Support CM002001

1 ¼” x ¾” Carriage Bolt GSM32000

1 ¼” Serrated Nut GSM30023

1 Pole Support Assembly CM93071-28W

1 Lateral Support Brace CM93146

1 Inner Telescoping Pole Assembly CM93072-3

Always

 Disconnect the vehicles’ battery. Removing seat bolts on some vehicles may give the

vehicles computer a false reading leading to warning lights on dash. This requires the

vehicles’ computer to be reset.

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use hardware provided with install kit.

 For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html

, email technicalsupport@havis.com or call

1-800-524-9900.

PAGE 1
3 INSTALL INSTRUCTIONS C-TCB-28 1997-2007 DODGE DAKOTA TELESCOPING COMPUTER BASE TOOLS REQUIRED: Ratcheting wrench 3/8” Metric Socket Set T-20 torx bit 3/8” Standard Socket Set HARDWARE: QTY DESCRIPTION 4 ¼” x 1” Hex head lag bolt 1 5/16” Flat Washer 1 5/16” Nylock Nut 1 “Z” Bracket Support 1 ¼” x ¾” Carriage Bolt 1 ¼” Serrated Nut 1 Pole Support Assembly 1 Lateral Support Brace 1 Inner Telescoping Pole Assembly Combination wrench set Powered Drill Drill Bit set PART # GSM33060 GSM31006 GSM30017 CM002001
PAGE 2
CM93072-3 CM93146 CM93071-28W Location of factory seat bolts Remove front bolts on passengerside seat and position base assembly in front of seat mount brackets. Tighten “Z” bracket to base assembly. Re-attach front bolts on passengerside seat through C-TCB base plate. Pre-drill floor of vehicle with 3/16” drill bit Use holes in the “Z” bracket as a drill template 2 Install “Z” support bracket to base assembly using ¼ x ¾” carriage bolt and serrated nut.
PAGE 3
Loosely attach lateral support brace to TCB base using 5/16” flat washer and 5/16” nylock nut Pre-drill floor of vehicle with 3/16” drill bit. Use holes in the support brace as a drill template Tighten 5/16” nylock nut Attach support brace to floor using ¼” x 1” hex head lag bolts Insert inner telescoping pole assembly and thread lock handle into pole support base assembly.