Parts and Owners Manual MOWER MODEL： SERIAL: ENGINE MODEL & HP: DATE PURCHASED: PURCHASED FROM： You must receive special training from the dealer before operating this mower.
COMMERCIAL MOWER OPERATORS MANUAL &PARTS LIST THIS MOWER IS INTENDED FOR COMMERCIAL USE SPECIAL TRAINING IS REQUIRED TO OPERATE THIS MOWER SAFELY MOWER MODEL： SERIAL: ENGINE MODEL & HP: DATE PURCHASED: PURCHASED FROM: ______________________________ IMPORTANT INFORMATION ABOUT THIS MANUAL This owner’s manual is considered a permanent part of mower. It must be available to all of the operatorsand/or person(s) servicing the mower. Should the mower be resold, this manual must remain with themower.
model number, serial number, and date of purchase, purchase price and from whom the unit was purchased. This warranty is limited to parts replacement only. Please retain the defective parts until the replacement parts are received. In some case, the parts may be requested to be returned. If parts are requested to be returned, they must be shipped prepaid and insured. Cost of shipping these parts is the responsibility of the owner or purchaser of the mower. .
STARTING & STOPPING 1. Fill the engine crankcase with oil. Refer to the engine instruction manual supplied with this mower. 2. Fill the gas tank. Refer to engine manual. 3. Pump primer bulb on engine, or set throttle control to proper position. TO START 1. Hold lever against the handlebar and pull recoil starter cord See figure 1 NOTE: Return cord slowly-DO NOT LET HANDLE SNAP！ Figure1 Figure 2 Figure 3 REMEMBER: The lever control must be held against handlebar to operate the mower.
1. In order for your safety controls to function at the peak of efficiency, they must be inspected and adjusted regularly. Initial inspection shall take place after the first two (2) hours. Belt tension is a very critical part of your safety inspection, and should be checked frequently. 2. Keep all nuts, bolts and screws tight to assure safe mower operation. 3. Never store equipment with gas in the tank or in a building near a spark or flame. Allow the engine to cool before storing in any enclosure. 4.
Item NO.
Item NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 Part Number 424B-025 400-034 400-028 400-001 424B-026 424B-027 424B-028 424B-029 424B-030 424B-031 424B-032 424B-033 424B-034 Description Plow handle Handle grip Bail weldment Grip Clutch guardⅡ Clutch Clutch guardⅠ connector panel Nylon Nut5/16 Engine Hexagon Bolt M6x12 GB5789 Engine washer Belt Guard 200-030 200-085 Nylon Nut M8 GB889-86 Hexagon Bolt M8X40 GB5782 424B-035 Eng.
Item NO.
