Instructions / Assembly
Remember to clip both sides of the front frame rod.
5. Repeat step 4 for the back frame rod (#3). Remember to clip both sides of
the back frame rod into the back frame clips (#5).
6. Remove the U-shaped lock rod (#6) from storage area at top of the cage
(illustration 5). After removing the lock rod, close back panel (#7). Back panel
should swing down when lock rod is removed.
7. Turn cage so you are facing the back panel (#7). With the straight end of the
U-shaped lock rod (#6) closest to the ground, take your right hand and thread
the straight end of the lock rod through the bottom hole of the retainer clip (#8)
and the hooked part of the lock rod through the side of the cage (illustration 6).
Thread rod through two retainer rings attached to the back panel so the
back of the cage is secure. Thread straight end of lock rod through the
bottom hole of the retainer clip on the left side of the cage. With your left hand
secure the hooked part of the lock rod to the left side of the cage (illustration
7).
8. Remove trigger rod (#14) from storage area at the top of the cage (illustration
8). Tipping cage away from you, thread trigger into loops on the underside of
trigger pan (# 9, illustration 9). Return cage to its upright position.
9. Cage is now set up.
10. Carton may be retained for cage storage.
Baiting the Stray Cat Rescue Cage
1. Remove U-shaped lock rod (#6) from the back panel (#7) by pressing in on left
side of cage to release hooked part of lock rod. Pull back panel toward you.
2.
While holding back panel up, place the bait approximately two inches from the
back of the cage. Do not place bait on the trigger pan(#9).
3.
Tip: One suggestion is to place the bait on a small square of tin foil
approximately 4"x4" in size. This will allow you to place the bait and bait juice
in the cage.
3.
Close back panel & relock using U-shaped lock rod.
REMEMBER: Always bait the cage before setting it.
Setting the Stray Cat Rescue Cage
TIP: Any camouflage or material you use to hide the cage, including the
cover, should not interfere with the operation of the cage in any way.
1. Viewing cage from front, position yourself on the right-hand side of
cage.
2. Lift the lock (#10) with your right hand.
3. Place the forefinger of your left hand through the loop (#11) on the
door of the cage and with your thumb, push the lock frame (#12) and
lift the door (illustration 10).
4. Set cage by pulling metal trigger (#13) forward with your right thumb
and forefinger until door is secured by trigger hook (illustration 11).
5. Gently release door. Cage is set.
6.
Tri
p
ca
g
e to make sure it is workin
g
p
ro
p
erl
y
. Tri
p
ca
g
e usin
g
a
p
en or
Illustration 5
Illustration 6