Instructions / Assembly

Table Of Contents

SNOWFALL CREEK PRE-LIT CHAIRBACK SWAG 20 INCH

Item # DCSW2003

Instructions:

1) Place the chair swag on a flat surface. Straighten and separate all branch tips. To achieve

maximum fullness, tips should not touch one another.

2) From back of the chair swag, find the battery box and open it, insert 3 AA batteries into the

battery box, then close it (see Figure A, B, C, D & E).

3) Each battery box is featured with a 3-position switch: On – Off – Timer (see Figure F) . The

timer enables the LED lights to remain on for 6 hours, then off for the next 18 hours. This

will repeat daily. Suitable for indoor or covered outdoor use.

4) Attach the swag to the highest part of the chair back using the included red fabric hook.

Squeeze gently to prevent sliding. The swag can also be displayed on a staircase railing.

PAGE 1
SNOWFALL CREEK PRE-LIT CHAIRBACK SWAG 20 INCH Item # DCSW2003 Instructions: 1) Place the chair swag on a flat surface. Straighten and separate all branch tips. To achieve maximum fullness, tips should not touch one another. 2) From back of the chair swag, find the battery box and open it, insert 3 AA batteries into the battery box, then close it (see Figure A, B, C, D & E). 3) Each battery box is featured with a 3-position switch: On – Off – Timer (see Figure F) .
PAGE 2
Battery Warning: 1. 2. 3. 4. Adult supervision is necessary when changing and disposing of batteries. Slide switch to "OFF" position when changing batteries. Confirm proper polarity when inserting batteries. Do not attempt to charge non-rechargeable batteries. Only recharge rechargeable batteries and do it under adult supervision. 5. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. 6. Replace batteries when the light is faint. 7.