Product Manual

Rev. 10.09.13 aj Page 4 of 4 ©2013 HAUSMANN INDUSTRIES, INC.
B) OPERATING INSTRUCTIONS (S320, S321, 1300, 1386, 1387, 1390, 1391, 1392 & 1393)
A. To Raise or Lower the bars:
1. Remove the locking pin from upright
2. Raise or lower the Adjustable height post to the
desired height, and insert the locking pin back
into upright to lock as shown in Figure 8.
3. Repeat steps 1 and 2 above to set the height for
other adjustable height posts.
B. To adjust the width between two bars: (N/A for
Model # 1300)
1. Loosen the control knobs on the adjustable "T"
by turning counterclockwise.
2. Move the adjustable arm in or out to the
desired position and tighten the control knob by
turning clockwise.
CAUTION:
Before each use, make sure all the control knobs and set screws are in place and tighten, or injury may occur.
Step Ladder and Balance Beam Placement Instructions (Model # 1393 only)
A. The Placement of Ladder Steps:
Alternate the steps by inserting into one holes “B” and “C”, then the second in “A” and “B”. Continuing as
required as shown in Figure 9 and 10.
B. The Placement of Balance Beam:
Insert the beam into the second to last holes in line ‘B’ from each end of the platform as shown in Figure 11.
NOTE: It is not necessary to remove the ladder steps prior to installing the balance beam. Balance beam is
designed to fit over previously installed steps.
Plan ‘A’ Plan ‘B’
Figure 8: Height & Width Adjustment
CONTROL KNOB
WIDTH
ADJUSTABLE
ARM
‘T’ FITTING
I
Figure 9: Step ladder placement
Figure 11: Balance beam placement
J
K
B
A
B
C
Figure 10: Ladder placed with Plan ‘A’ and ‘B’
Pediatric Add-On Fitting
Figure 12: 1384 Combination Adult/Child Parallel Bar