User Guide

To set up the IR Blaster, see the guide
IRRemoteBlaster Quick
Installation Guide for WinTV v7.
Learning remote control
codes for your set top box
First make sure the WinTV IR trans-
mitter is positioned over the remote
sensor on your set top box.
Remember, the WinTV IR transmit-
ter has a very short transmission dis-
tance and needs to be positioned
over the remote sensor on your set
top box.
To access the learn function in
BlastConfig.exe, click on
Advanced
Config and Learn.
You will need to ‘learn’ the 0 through
9 keys, plus Power on and Enter. To
learn the new keys:
-
hold the remote control from
your set top box as close to the
IR receiver and learn sensor
as possible
- in the Blaster config program, click the button you would like to learn (for
example: 1)
- then depress and hold the corresponding key on your set top box remote con-
trol. You will be instructed in the message box when to release the key onyour
remote control.
- Do this for the keys 0 to 9 plus On and Enter
You should receive a LearnKey(key#) Succeeded message. Then move on to
the next key.
If you receive a LearnKey(key#) Failed error, this means that the key was either
held down too long, or not long enough, or that the remote was not held close
enough to the IR sensor on the HD PVR. Try again.
Once you are finished with the numbers 0 to 9 and On and Enter, you can test
page 19
Message box
Key numbers
Send button