Installation Guide

Schematic diagram

Component list

No. Name Quantity

1 Adapter 1 pc

2,3 Power Wire (longer +shorter) 2 pc

4 Holder - Lower 1 pc

5 Holder– Middle 1 pc

6 Holder– Upper 1 pc

7 Lamp 1set

8 Topper 1 pc

9 Screws (bigger +smaller） 4+8 pcs

1,2,3,4

All wire connectors.

Caution

• This product is fragile and should be assembled with care.

• Please follow the below steps and requirements specified in the instruction to ensure

safety and reliability during the installation.

PAGE 1
• • Caution This product is fragile and should be assembled with care. Please follow the below steps and requirements specified in the instruction to ensure safety and reliability during the installation. Schematic diagram Component list No. Name Quantity 1 Adapter 1 pc 2,3 Power Wire (longer +shorter) 2 pc 4 Holder - Lower 1 pc 5 Holder– Middle 1 pc 6 Holder– Upper 1 pc 7 Lamp 1set 8 Topper 1 pc 9 Screws (bigger +smaller） 4+8 pcs 1,2,3,4 All wire connectors.
PAGE 2
Assembly Instructions 1) Assemble the holder Anchor points Assemble the 3 parts of the holder into a hole with 8 screws. Note: Be sure to have the corresponding anchor points lined up correctly before fixing. 2) Connect wires Anchor points (A) Thread the shorter power wire and its connector (4) through the holder and then fix the holder onto the bottom of lamp with 4 bigger screws. (B) Fix two connectors (3) and (4) to combine two power wires of 2 and 3.