Use and Care Manual

1) Install lamp base

Please assemble the product from the bottom to the up,

following the main steps below:

A. Assemble lamp base (9) and square base (10) with 4

screws:

B. Assemble 4 pieces of additional base (7) into a whole,

and then assemble the whole additional base (7) with the

lamp base (9).

Note: The base trim (7) is especially designed to fasten the

street lamp more securely. The base trim does not need to

be installed if the following applies: street lamp is installed

on a flat ground and there is no external force (such as high

winds) to bring it down or if the street lamp is used outdoor

and it can be fixed on the ground by fastening ground nails.

2) Install lamp post

Screw the 2 upper and lower posts (3), lamp post joints (12)

and square lamp base (10) together according to the

sequence shown in the figure below. Note: Every screw

thread must be tightened; otherwise, the lamp posts may

lean.

3) Install lamp holder

A. Thread the power wire (6) and its joint (5) through the

lamp base and lamp post (the lamp base and lamp post

can be laid down or put upside down for convenience. After

drawing out the joint (5), place it correctly for later use);

B. Take out the lamp holder (2) and put on the lamp top (1);

C. Draw out the joint (6) and the power line (13), connect

the joints (5) and (6), put the combined joints and their

wires into lamp post (3). Note: At this time, it will be better

to ask another person to hold the lamp holder (2) for a

more secure assembly.

D. Rotate the lamp holder (2) to fasten it on the lamp post

(3). Note: The screw thread shall be tightened as far as

possible. Meanwhile the direction of the lamp holder (2)

shall be slightly adjusted to make it match the direction of

the lamp bases (9) and (10).

Assembly Instructions