User Manual

9. (Continued) Drill and attach middle crossbar / leg assembly
Mark the location of the square holes in the ribbed middle crossbar end brackets on the underside of the
rectangle side rail tube. For best results use a pencil or marker and trace the outline of the square holes
onto the rail. Repeat for other side.
Slide the front leg / middle crossbar assembly backwards enough to gain clearance to drill.
With a pencil or marker, draw lines from corner to corner on square outlined on the rail.
For best results, use a center punch to mark the intersection of the two lines before drilling.
Carefully drill (2) 3/8” hol es straight up through the rectangle tube in each side. Note y ou cannot drill
down from the top as the round tube rail is in the way and will prevent drilling a straight hole.
Slide the front leg / middle crossbar assembly forward after drilling both sides.
Use (2) 3/8”-16 x 2” carriage bolts, (2) 3/8” split lo ck washers and (2) 3/8”-16 nuts to attach the front leg /
middle crossbar assembly to the top side railing. Repeat for other side. Finger tigh ten only.
HAULER RACKS, INC. Toll Free: 1-800-843-5445
7109 31
st
Avenue North Phone: 763-546-5620
Minneapolis, MN 55427-2848 Fax: 763-546-0933
Page 12 of 14 WWW.HAULERRACKS.COM