User Manual

Pinout Assignments - Common Connectors
43
IND100241-22
Appendix
Additional connector pinouts may be available in third party motherboard manuals, primarily for computers only.
Please see manual/drivercd delivered with your product or own section in this user manual.
9-pin Ampli ed Mono/Stereo Audio Out, DSUB Female
Type Number “HT 00235 OPT-A1”
5 4 3 2 1
9 8 7 6
PIN 01 LAUDR Left Audio Return*
PIN 02 LAUD Left Audio*
PIN 03 RAUDR Right Audio Return
PIN 04 RAUD Right Audio
PIN 05 N/C No internal connection
PIN 06 N/C No internal connection
PIN 07 N/C No internal connection
PIN 08 N/C No internal connection
PIN 09 N/C No internal connection
*For Mono: connect pin 01 and 02 only
25-pin Female Parallel (Optional for selected computers)
13 12 11 10 9 8 7 6 5 4 3 2 1
25 24 23 22 21 20 19 18 17 16 15 14
Pin 01 STROBE This signal indicates to the printer that data at PD7..0 are valid.
Pin 02 DATA0 Parallel data bus from PC board to printer. The data line are able to operate in PS/2 compatible bi-directional mode.
Pin 03 DATA1 Same as Pin 02
Pin 04 DATA2 Same as Pin 02
Pin 05 DATA3 Same as Pin 02
Pin 06 DATA4 Same as Pin 02
Pin 07 DATA5 Same as Pin 02
Pin 08 DATA6 Same as Pin 02
Pin 09 DATA7 Same as Pin 02
Pin 10 ACK Signal from printer indicating that the printer has received the data and is ready to accept further data.
Pin 11 BUSY Signal from printer indicating that the printer cannot accept further data.
Pin 12 PE Signal from printer indicating that the printer is out of paper.
Pin 13 SELECT Signal from printer to indicate that the printer is selected.
Pin 14 AUTO FEED This active low output causes the printer to add a line feed after each line printed.
Pin 15 ERR# Signal from printer indicating that an error has been detected.
Pin 16 INIT# This active low output initialises (resets) the printer.
Pin 17 SLIN# Signal to select the printer sent from CPU board to printer.
Pin 18 GND Ground
Pin 19 GND Ground
Pin 20 GND Ground
Pin 21 GND Ground
Pin 22 GND Ground
Pin 23 GND Ground
Pin 24 GND Ground
Pin 25 GND Ground
Analog RGB/VGA, 15-pin DSUB High Density Female
5 4 3 2 1
15 14 13 12 11
10 9 8 7 6
PIN 01 RED Red, analog
PIN 02 GREEN Green, analog
PIN 03 BLUE Blue, analog
PIN 04 ID2/RES Reserved for monitor ID bit 2 (grounded)
PIN 05 GND Digital ground
PIN 06 RED_RTN Analog ground red
PIN 07 GREEN_RTN Analog ground green
PIN 08 BLUE_RTN Analog ground blue
PIN 09 KEY/PWR +5V power supply for DDC (optional)
PIN 10 GND Digital ground
PIN 11 ID0/RES Reserved for monitor ID bit 0 (grounded)
PIN 12 ID1/SDA DDC serial data
PIN 13 HSYNC. Horizontal sync or composite sync, input
PIN 14 VSYNC. Vertical sync, input
PIN 15 ID3/SCL DDC serial clock