Owner's manual

ManualsBrandsHatteland Display ManualsMonitors26 inch - HD 26T21 MMD (Widescreen, Touch Screen)

IND100129-167

All specifications are subject to change without prior notice!

Specications - HD 26T21 MMD-xxx-FxxC (LED/CCFL version)

SPECIFICATIONS

Note: All speciﬁ cations are subject to change without prior notice!

Please visit www.hatteland-display.com for the latest electronic version.

2/2

• W:621.40 [24.46''] x H:435.40 [17.14''] x D:105.20 [4.13''] mm [inch]

• 4 x M6 VESA mounting 280x150mm, Max 12mm deep

• Weight: 15.5kg / 34.1lbs

• High Quality TFT with LED or CCFL Backlight Technology

• 25.54 inch viewable image size, Widescreen, Aspect Ratio 16:10

• S-MVA, Active Matrix, Thin Film Transistor (TFT)

• RGB Vertical Stripe

• Native Resolution : 1920 x 1200

• Pixel Pitch (RGB) : 0.2865 (H) x 0.2865 (V) mm

• Response Time (CCFL) : 8 ms (typical), "gray" to "gray"

• Response Time (LED) : 20ms (Tr+Tf)

• Contrast Ratio : 1500:1 (typical)

• Light Intensity : 350 cd/m

(typical)

• Viewable Angle : +/- 88 deg. (typical) (Up/Down/Left/Right)

• Active Display Area : 550.08 (H) x 343.8 (V) mm

• Max Colors : 16.7 million

Multi-power Supply:

• 115&230VAC - 50/60Hz + 24 VDC - HD 26T21 MMD-Mxx-FxxC

Note: You may connect either AC power or DC power or both. In case both sources

are connected, power will be sourced from the AC input. If AC input is lost, there will

be a uninterrupted switch-over to DC input.

Power Consumption:

• Operating AC/DC: 107W (typ) - 125W (max)

A P P R O V A L S & C E R T I F I C A T E S

Physical Considerations:

TFT Technology:

TFT Characteristics:

Power Specifications:

This product have been tested / type approved by the following classification societies:

IEC 60945 4th (EN 60945:2002) IACS E10 ClassNK - Nippon Kaiji Kyokai GL - Germanischer Lloyd

DNV - Det Norske Veritas ABS - American Bureau of Shipping CCS - China Classification Society BV - Bureau Veritas

LRS - Lloyd’s Register of Shipping EU RO MR - Mutual Recognition

• Digital separate synchronization

• Composite synchronization

• Synchronization on green

• Auto detects VGA -> WUXGA, interlaced and non interlaced

• Video Signal : Analog RGB 0,7Vp-p

: Input Impedance 75 Ohm

Synchronization Range:

• Horizontal : 31.5 kHz to 91.1 kHz

• Vertical : 60 Hz* to 85 Hz

* Recommended for optimal picture quality

Resolutions:

• VGA : 640 x 480 (including 640 x 350)

• SVGA : 800 x 600 (including 720 x 400)

• XGA : 1024 x 768

• SXGA : 1280 x 1024

• UXGA : 1600 x 1200

• FHD : 1920 x 1080

• WUXGA : 1920 x 1200*

* Recommended for optimal picture quality

Video Signals:

• Interlaced HDTV, NTSC, PAL and SECAM video

• Composite video

Synchronization:

Supported Signals:

• DVI-D Signal IN : 2 x 24p DVI (female)

• RGB Signal IN : 2 x 15p HD D-SUB (female)

• Comp. Video IN : 3 x BNC Connector (female)

• SCOM RS-422/485 : 1 x 5-pin Terminal Block 3.81, non-isolated+Buzzer

• RGB Signal OUT : 1 x 15p HD D-SUB (female) - Clone of RGB IN*

• Touchscreen : 1 x USB TYPE A Connector (female)

• Ethernet : 1 x RJ45 Connector for Remote Control

• SCOM RS-232 : 1 x 9p D-SUB (female) non-isolated

• Potmeter : 1 x 9p D-SUB (male)

(Potentiometer IN, +5VDC OUT, BRT +/- IN)

• AC Power IN : 1 x Std IEC Inlet

• DC Power IN : 1 x 2-pin Terminal Block 5.08

*Tested at recommended resolutions. The RGB output signal is at same resolution and

sync as the RGB input. The output is working even if the display unit is turned off, but

power cable/supply must be connected/provided.

Signal Terminals:

• Operating : Temperature -15 deg. C to +55 deg. C

- Humidity up to 95%

• Storage : Temperature -20 deg. C to +60 deg. C

- Humidity up to 95%

• IP Rating : Protection: IP66 front – IP22 rear (EN60529)

• Compass Safe Dist. : HD26T21MMD-xxx-Fxxx - Std: 130cm Steering: 70cm

Lifetime Considerations:

Even although the test conditions for bridge units provide for a maximum

operating temperature of 55°C, continuous operation of all electronic

components should, if possible, take place at ambient temperatures of only

25°C. This is a necessary prerequisite for long life and low service costs.

Behind front bezel - Glass Display Control™ (GDC) IP66:

• Power On/Off, On Screen Display Menu, Brightness Control (-/+)

• Hotkeys (left/right), Mode Status Indicators (ECDIS, Service)

• Buzzer (not visible), Light Sensor (not visible)

• Color Calibrated models (ECDIS)

• Single AC Power 115&230VAC - 50/60Hz Input

Environmental Considerations:

User Controls:

Factory Options:

For a full overview of typenumbers, please review the following link:

www.hatteland-display.com/pdflink/ind100780-3.php

• HD CMB SX1-C1 : 1 x Console Mount Kit. EN60945 Tested

• HD TMB SX1-C1 : 1 x Table Mount Bracket. EN60945 Tested

• HD VED SX1-C1 : 1 x VESA Bracket, not EN60945 Tested

Please see user manual/datasheet for more information

Available Accessories:

• Optical Bonding Technology

• Capacitive Touch Screen (USB interface)

• Cosmetic aluminum front frame

Factory Defaults:

w/Touch Screen