Owner's manual

ManualsBrandsHatteland Display ManualsMonitors26 inch - HD 26T21 MMD (Widescreen, Touch Screen)

IND100129-143

All specifications are subject to change without prior notice!

Specications - HD 15T21 MMD-xxx-Fxxx

SPECIFICATIONS

Note: All speciﬁ cations are subject to change without prior notice!

Please visit www.hatteland-display.com for the latest electronic version.

2/2

• Native Resolution : 1024 x 768

• Pixel Pitch (RGB) : 0.297 (H) x 0.297 (V) mm

• Response Time Standard : 8ms (typical), black to white

• Response Time High Bright : 19ms (typical), black to white

• Contrast Ratio Standard : 700:1 (typical)

• Contrast Ratio High Bright : 800:1 (typical)

• Light Intensity Standard : 400 cd/m² (typical)

• Light Intensity High Bright : 1000 cd/m² (typical)

• Viewable Angle Standard : +/- 80 deg. (Up/Down/Left/Right) (typical)

• Viewable Angle High Bright : +/- 80 deg. (D/L/R), +/- 60 deg. (U) (typ)

• Active Display Area : 304.1 (H) x 228.1 (V) mm

• Max Colors : 16.7 million

• W:356.00 [14.02''] x H:307.00 [12.09''] x D:71.50 [2.81''] mm [inch]

• 4 x M6 VESA mounting 280x150mm, Max 12mm deep

• Weight: 4.9kg / 10.8lbs

• High Bright only: Includes an EPDM sealing gasket (IP66 console mount).

• High Quality TFT with LED Backlight

• 15.0 inch viewable image size, Aspect Ratio 4:3

• TFT active-matrix liquid crystal panel

Multi-power Supply:

• 115&230VAC - 50/60Hz + 24 VDC - HD 15T21 MMD-Mxx-Fxxx

Note: You may connect either AC power or DC power or both. In case both sources

are connected, power will be sourced from the AC input. If AC input is lost, there will

be a uninterrupted switch-over to DC input.

Power Consumption:

• Operating Standard : 22W (typ) - 60W (max)

• Operating High Bright : 34W (typ) - 60W (max)

A P P R O V A L S & C E R T I F I C A T E S

Physical Considerations:

TFT Technology:

TFT Characteristics:

Power Specifications:

This product have been tested / type approved by the following classification societies:

IEC 60945 4th (EN 60945:2002) IACS E10 ClassNK - Nippon Kaiji Kyokai

GL - Germanischer Lloyd DNV - Det Norske Veritas ABS - American Bureau of Shipping

CCS - China Classification Society BV - Bureau Veritas LRS - Lloyd’s Register of Shipping

EU RO MR - Mutual Recognition

Compass Safe Distance: HD 15T21 MMD-xxx-Fxxx Standard: 125cm Steering: 75cm

• Digital separate synchronization

• Composite synchronization

• Synchronization on green

• Auto detects VGA -> XGA, interlaced and non interlaced

• Video Signal : Analog RGB 0,7Vp-p

: Input Impedance 75 Ohm

Synchronization Range:

• Horizontal : 31.5 kHz to 91.1 kHz

• Vertical : 60 Hz* to 85 Hz

* Recommended for optimal picture quality

Resolutions:

• VGA : 640 x 480 (including 640 x 350)

• SVGA : 800 x 600 (including 720 x 400)

• XGA : 1024 x 768*

* Recommended for optimal picture quality

Video Signals:

• Interlaced HDTV, NTSC, PAL and SECAM video

• Composite video

Synchronization:

Supported Signals:

• DVI-D Signal IN : 2 x 24p DVI (female)

• RGB Signal IN : 2 x 15p HD D-SUB (female)

• Comp. Video IN : 3 x BNC connector (female)

• SCOM RS-422/485 : 1 x 5-pin Terminal Block 3.81, non-isolated+Buzzer

• RGB Signal OUT : 1 x 15p HD D-SUB (female) - Clone of RGB IN*

• If Touchscreen : 1 x USB TYPE A Connector (female)

• Ethernet : 1 x RJ45 Connector for Remote Control

• SCOM RS-232 : 1 x 9p D-SUB (female) non-isolated

• Potmeter : 1 x 9p D-SUB (male)

(Potentiometer IN, +5VDC OUT, BRT +/- IN)

• AC Power IN : 1 x Std IEC Inlet

• DC Power IN : 1 x 2-pin Terminal Block 5.08

*Tested at recommended resolutions. The RGB output signal is at same resolution and

sync as the RGB input. The output is working even if the display unit is turned off, but

power cable/supply must be connected/provided.

Signal Terminals:

• Operating : Temperature -15 deg. C to +55 deg. C

- Humidity up to 95%

• Storage : Temperature -20 deg. C to +60 deg. C

- Humidity up to 95%

• IP Rating : Protection: IP66 front - IP22 rear (EN60529)

Lifetime Considerations:

Even although the test conditions for bridge units provide for a maximum

operating temperature of 55°C, continuous operation of all electronic

components should, if possible, take place at ambient temperatures of only

25°C. This is a necessary prerequisite for long life and low service costs.

Behind front bezel - Glass Display Control™ (GDC) IP66:

• Power On/Off, On Screen Display Menu, Brightness Control (-/+)

• Hotkeys (left/right), Mode Status Indicator (Service)

• Light Sensor (not visible), Buzzer (not visible)

• Projected Capacitive Touch Screen (Multitouch, USB interface)

• Optical Bonding Technology

• Sunlight Readable / High Bright (includes Optical Bonding) model

Environmental Considerations:

User Controls:

Factory Options:

For a full overview of typenumbers, please review the following link:

www.hatteland-display.com/pdflink/ind100780-3.php

• HD CMB SX1-A1 : 1 x Console Mount Kit (3-12mm). EN60945 Tested

• HD CMB SX1-A2 : 1 x Console Mount Kit (1-12.75mm). EN60945 Tested

• HD CMB SX1-A3 : 1 x Console Mount Kit (1-12.75mm). EN60945 Tested

Long screws for easier installation in tight spaces.

• HD TMB SX1-A1 : 1 x Table Mount Bracket. EN60945 Tested

• HD VED SX1-A1 : 1 x VESA Bracket, not EN60945 Tested

• JH 15TAP STD-C1 : 1 x Frame Adapter (15" Series 1 to Series X) retrofit

Please see user manual/datasheet for more information

Available Accessories: