Manual

31
User Controls
IND100064-19
BRIGHTNESS AND CONTRAST: (No function for DVI signals)
Selecting this function will enable the user to adjust brightness and contrast
for the display.
(No Function for DVI) BRIGHTNESS: Increase/decrease brightness level, total: 100 steps
(No Function for DVI) CONTRAST: Increase/decrease contrast level, total: 100 steps
COLOR TEMPERATURE :
Selecting this function will enable the user to modify the warmness of the picture.
Higher temperature = “cooler” picture. Lower temperature = “warmer” picture.
User can select between 9500K, 8000K, 6500K, and 5000K color temperature measured in
Kelvin degrees. Press “+” to access the sub-menu, where the RGB values can be adjusted.
Use “+” and “-” buttons to adjust these values, and “MENU” to exit. (Saving is done automatically)
FREQUENCY AND PHASE: (Some functions not available for DVI signals)
Selecting this function will enable the user to modify the image horizontal size and
ne tune the image quality.
(No Function for DVI) FREQUENCY: Increase/decrease the image horizontal size.
(No Function for DVI) PHASE: Fine tune the data sampling position (adjust image quality.)
(No Function for DVI) SHARPNESS: Increase/decrease video image sharpness level.
PICTURE TYPE : Motion / Still (Adjustment for best image quality)
If graphics on screen move a lot, select “Motion”
If graphics on screen are mostly still, select “Still”
STATUS:
Selecting this function will display graphic information such as resolution and
frequency.
POSITION: (No function for DVI signals)
Selecting this function will enable the user to position the image within the display
area.
(No Function for DVI) IMAGE UP/DOWN : Position the image vertically using “UP” or “DOWN” buttons.
(No Function for DVI) IMAGE LEFT/RIGHT : Position the image horizontally using “+” or “-” buttons.
OSD Menu Functions
2
2
1
2
1
2
1
2