Manual

18
IND100078-20
General Installation Recommendations
Installation
EMI / Water Sealing Gasket (17 x 2 holes version)
This gasket is only applicable for NMD models. Comes with adhesive tape:
3M 9080-High Performance Non-woven Double Coated Tape.
To mount it correctly, please review the quick guide below.
1: Clean the bright surface with isopropanol as red area in FIG 2 shows.
2: Remove the protection paper from the gasket (FIG 1).
3: Now mount the gasket to the unit as shown in FIG 3.
Make sure that the holes in the gasket ts the guide pins
(on each side/top) and that it aligns with the holes in the
mounting frame.
4: Press rmly with two ngers around on the entire gasket
(FIG 4) to make sure it is glued properly and that possible
air bubbles are not present underneath the gasket.
FIG 2
FIG 3
FIG 4
FIG 1