Instruction Manual

5
Fig. 8
Section VII. OPERATING INSTRUCTIONS
Warning!
1. Before filling the air cylinder; make sure the air rifle is not cocked, safety is in
the ON position, no pellets are loaded in the air rifle and/or barrel and magazine
is not mounted in the gun. If the air tube is completelly empty; fill in air tube
after cocking the gun and keeping the cocking handle/bolt open at the rear.
2. Take all safety measures before filling the air cylinder. It is compulsory for the
user and bystanders to wear eye & ear protection when filling the air cylinder.
3. While filling in the air cylinder; the pressure in the air cylinder must be monitored
from the air gauge of the hand pump or scuba charging kit. Do not look at the air
gauge on the air cylinder during filling process. Instead, reference the gauge on
your fill device.
Charging the Rifle: Fit the filler nozzle to the air-line of the charging equipment, which must
incorporate a pressure gauge. Ensure both filler nozzle and rifle filler hole are clear from dirt and gently
push the nozzle into the filler hole. Fill the rifle to the cylinder pressure quoted previously in this manual.
Do not exceed the maximum fill pressure as this will reduce the velocity of the rifle and may damage
rifle components. When using the diver’s bottle, refill the rifle slowly to prevent the heat created by
the filling process from damaging the rifles components. Undo the bleeder valve on the hose before
disconnecting the fill nozzle from the rifle.
Note: You can assemble spare air cylinder to your rifle. In order to do that, first remove the air cylinder
mounted on the rifle by turning it counter-clockwise. Then assemble the spare air cylinder by aligning and
rotating it clockwise. Your air cylinder can be filled either on or off of the rifle.
Loading the rifle & shooting
1. The magazine incorporates a raised boss on its rear face and can only be fitted one way to the rifle. It
rotates clockwise when viewed from the rear of the rifle.
2. Load pellets through the rear of the magazine. (Fig. 8). Push the pellet noses through the retaining
O-ring until their skirts lie flush or below the bottom of the magazine face.
3. To fit the magazine into the air rifle; pull the cocking handle backwards until it stops.
THIS OPERATION COCKS THE TRIGGER MECHANISM/HAMMER
ASSEMBLY. IF THE SAFETY IS SET TO OFF POSITION AND THE
TRIGGER IS PULLED, THE RIFLE WILL DISCHARGE.
4. Push forward the magazine release bolt and slide it upward to lock. Insert
the magazine into its slot from the right.
5. Unlock magazine release bolt by sliding it down and backwards. (Fig. 9).
If necessary rotate the magazine counter-clockwise until its movement is
arrested by the magazine stop.
Fig. 6 Fig. 7
Filler
Nozzle