Instruction Manual

4
Section III. MANUAL SAFETY
Safety button can be set to ‘ON’ and ‘OFF’ position manually.
• To set the safety to ‘ON’, pull safety lever to the rear. In this position, the trigger cannot be pulled and the gun
cannot be fired. (Fig.1)
• To remove the safety to ‘OFF’, push safety lever forward. In this position, the gun is ready to shoot. (Fig. 2)
CAUTION: Until you are actually ready to shoot, keep the safety in the “ON” position (Fig. 1).
Fig. 1 Fig. 2
Fig. 3
Safety ON Safety OFF
Section IV. QUATTRO TRIGGER
Your air rifle is equipped with a Quattro trigger, (Fig. 3). You can adjust
the “trigger travel” & “trigger pull” as follows:
SCREW#1 is for trigger pull force adjustment. For less trigger pull force
prior to discharge, rotate SCREW#1 clockwise; and vice
versa.
SCREW#2 is for trigger travel adjustment. For less trigger travel prior
to discharge, rotate SCREW#2 clockwise; and vice versa.
SCREW#3 is for adjusting the force to pull the trigger until the end of the 1st stage. When this is turned clockwise,
this force increases; and vice versa.
* In order to access this adjustment, the adjustable butt pad must be pulled out slightly – See Section VI for instructions.
NOTE: Make only small changes to one adjuster at a time. Over-adjusting can render the trigger inoperable and may create
a dangerous situation!
Section VI. COMFORT ADJUSTMENTS
Comb Adjustment: The comb is adjustable for elevation. Simply rotate the knurled adjuster located beneath the
comb and adjust the comb elevation suitable to your aiming position. (Fig. 4 & Fig. 5)
Fig. 4 Fig. 5
Screw#3 Screw#2 Screw#1
Stock Length of Pull Adjustment: The butt pad is adjustable for length of pull. Simply loosen the 2 screws
located on the right side of the stock and adjust the butt pad suitable to your reach. Then tighten the screws so the
pad becomes solid. The screws can be adjusted with a suitable screw driver or with a coin. (Fig. 6 & Fig. 7)
Butt Pad Adjustment: The butt pad is adjustable for height and it rotates slightly, providing you the
perfect height and angle of the butt pad. In order to adjust the butt pad, simply loosen the bolt in the butt pad with a
suitable hex wrench; and raise or lower it according to shooting preference. Then tighten the bolt. (Fig. 6 & Fig. 7)