Instruction Manual

5
*Undo the bleeder valve on the hose before disconnecting the fill nozzle from the rifle.
You can assemble spare air cylinder to your rifle. In order to do that, first remove the air
cylinder mounted on the rifle by turning it counter-clockwise. Then assemble the spare
air cylinder by aligning and rotating it clockwise.
Loading the rifle & shooting :
1. The magazine incorporates a raised boss on its rear face and can only be fitted
one way to the rifle. It rotates clockwise when viewed from the rear of the rifle. The
groove on the side of the barrel housing allows you to observe whether the next
magazine chamber about to rotate into alignment with the barrel is loaded with a
pellet or empty.
2. To remove the magazine, pull the forearm slide until it locks and push forward
the magazine release bolt and lock it at the forward position. Then remove the
magazine by pulling it to the right (Fig. 7). THIS OPERATION COCKS THE TRIGGER
MECHANISM/HAMMER ASSEMBLY. IF THE SAFETY IS SET TO OFF POSITION AND
THE TRIGGER IS PULLED, THE RIFLE WILL DISCHARGE.
3. Load pellets through the rear of the magazine (Fig. 8). Push the pellet noses through
the retaining O-ring until their skirts lie flush or below the bottom of the magazine
face.
4. Assemble back the loaded magazine. Then release the magazine release bolt so that it locks at the
rear. (Fig. 9). If necessary rotate the magazine counter-clockwise until its movement is arrested by the
magazine stop.
DO NOT CLOSE THE FOREARM SLIDE UNTIL YOU ARE READY TO SHOOT. ENSURE THE FOREARM
SLIDE IS FULLY CLOSED BEFORE SHOOTING THE RIFLE AS ITS PERFORMANCE WILL BE AFFECTED
IF NOT FULLY CLOSE.
5. Push back the forearm slide as shown in Fig. 9.
6. Sight-in either with sights or other optic sights; disengage safety and get ready
for shooting.
7. Pull the trigger gently and the rifle will shoot.
8. To reload rifle, pull the foream slide fully and close so the next pellet
is indexed with the barrel. Then repeat above items 6 & 7.
Note: As the pellets are used and the magazine rotates, its empty chambers
become visible above the barrel housing. These chambers may be refilled as they
are revealed without removing the magazine if desired.
Note: You cannot cock the rifle and index the next pellet in the magazine unless you shoot the previous
pellet in the barrel. This is because of a feature which prevents more than one pellet being loaded in the
barrel which may cause damage to the rifle.
Fig. 8
Filler
Nozzle
Fig. 6
Fig. 7 Fig. 9
2
2
3
3
1
1