Instruction Manual

4
• Safety button can be set to ‘ON’ and ‘OFF’ position
manually.
• To set the safety to ‘ON’, pull safety button. In this
position, the trigger cannot be pulled and the gun
cannot be fired. (Fig.1)
• To remove the safety to ‘OFF’, push safety button. In
this position, the gun is ready to shoot. (Fig. 2)
Fig. 1
Safety ON
Fig. 2
Safety OFF
Section III. MANUAL SAFETY
CAUTION: Until you are actually ready to shoot, keep the safety button in the “ON” position (Fig. 1).
Section V. Quattro Trigger
Your air rifle is equipped with Quattro trigger, (Fig. 3), you can adjust “trigger
travel” & “trigger pull” as follows:
BOLT#1 is for trigger pull force adjustment.
For less trigger pull force prior to discharge, rotate BOLT #1 clockwise; and
vice versa.
BOLT#2 is for trigger travel adjustment.
For less trigger travel prior to discharge, rotate BOLT #2 clockwise; and vice
versa.
BOLT#3 is for adjusting the trigger force to pull the trigger till the end of 1st
stage. When this is turned clockwise, this force increases; and vice versa.
Your air rifle come with fiber optic rear & front sight fitted-except on
models with fixed noise-dampener whereas you should fit a scope or
other alternate optic sights..
The rear-sight is a sensitive device and can be adjusted both for eleva-
tion and windage.
Windage adjustment
• If the shot is deflected to the left of the target, turn the KNOB1
clockwise. (Fig. 4)
• If the shot is deflected to the right of the target, turn the KNOB1
counter-clockwise. (Fig. 4)
Elevation adjustment
• If the shot is too high, turn KNOB2 clockwise. (Fig. 4)
• If the shot is too low, turn KNOB2 screw counter-clockwise. (Fig. 4)
Further elevation adjustment is possible by means of the adjustable
front sight.
• If the shot is too high, turn KNOB3 clockwise. (Fig. 5)
• If the shot is too low, turn KNOB3 counter-clockwise. (Fig. 5)
Fig. 3
Fig. 4
Fig. 5
Knob#2
Knob#1
Knob#3
Section V. MICRO ADJUSTABLE REAR-SIGHT & ADJUSTABLE
FRONT SIGHT
Section VI. OPERATING INSTRUCTIONS
Charging the Rifle:
Fit the filler nozzle to the air-line of the charging equipment, which must incorporate a pressure gauge.
Ensure both filler nozzle and rifle filler hole are clear from dirt and push the nozzle into the filler hole.
Fill the rifle to the cylinder pressure quoted previously in this manual. Do not exceed the maximum fill
pressure as this will reduce the velocity of the rifle and may damage rifle components. When using the
divers bottle, refill the rifle slowly to prevent the heat created by the filling operation damaging the rifles
components.
BOLT#3
BOLT#2
BOLT#1