Product Manual

6
USER INSTRUCTIONS
Setting Up the System for Use
Connect DC power plug to the jack on the back of the con-
trol box, then plug the AC power plug into the outlet. Press
the power button on the monitor. At this point you should
have lights on the camera and a picture on the monitor. You
are now ready to perform the inspection procedure.
Alternatively, you may wish to use 18V Milwaukee com-
patible batteries for ultimate portability. Standard 3.0Ah
batteries should allow the user to run for 4-6 hours in a sin-
gle charge. Batteries are sold separately.
Locating Sonde
Push the “Counter/Sonde” button to turn the sonde on or
off. A symbol will appear next to the footage counter on
screen when the sonde is on. Use any brand of 512hz loca-
tor to find the sonde when underground. Sondes are locata-
ble up to 15ft. dependent upon thickness of concrete and
presence of steel/cast iron pipe.
Footage Counter
Push the “Counter/Sonde” button to move the counter
around the screen or hold it for 3 seconds and the counter
will flash, let it go and the count will reset.
Camera Lights
Camera lights can be controlled using the light up/down
buttons on the front of the monitor.