Use and Care Manual

1. Insert pre-assembled BLUE PLAYER RODS and GREEN PLAYER RODS into one SIDE PANEL

#7 as shown below. Note: Although this table is assembled upside down, players are shown up-

right for clarity. Each team should face the opposite goal when table is turned over. Ensure that

FOAM BUMPERS and PLASTIC ROD WASHERS are in place before inserting rods.

2. Insert PLAYER RODS into remaining SIDE PANEL #7.

3. Attach one END PANEL #8 to one end of the table with 1-1/2" FLAT SCREW #5 using pre-

EXAMPLE OF BLUE

3 PLAYER ROD ASSEMBLY:

ASSEMBLY INSTRUCTIONS

Note: Players should face

opposing goal when upright.

drilled holes. Make sure panel edges are ush at top and hand insert all screws before tightening.

Do NOT overtighten screws.