Instruction Manual

English
Form No. GRSM-0121

TROUBLESHOOTING GUIDE
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco for
assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com, select the Support pull-
down menu, and click on “Find A Service Agent”; or contact the Hatco Parts and Service Team at:
Telephone: [phone] or 414-671-6350
e-mail: [e-mail]
Divider Rods (GRSB Models Only)
Divider rods are available as an accessory for GRSB models.
To install the channel dividers and product divider rods:
1. Position the channel dividers on the front edge and back
edge of the unit.
2. Place the product divider rods into the channel dividers.
The rods can be adjusted easily to separate holding areas
as needed.
Channel
Divider
Product
Divider Rod
Divider Rod Installation
Wire Rack Mounting Kit
GRS units can be installed on a wire shelf. Use the following
procedure to install a unit to a wire shelf using the wire rack
mounting kit accessory.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. The location should be level to prevent
unit or its contents from falling accidentally and strong
enough to support the weight of unit and contents.
1. Remove the feet from the bottom of the unit.
2. Place unit on a wire shelf.
3. Secure the unit to the wire shelf using the supplied bolts
and washers.
Washer
Bolt
Wire Rack Mounting Kit Installation
OPTIONS AND ACCESSORIES