User Guide

Form No. GRMM-0399
5
MAINTENANCE
CLEANING
Hatco Glo-Ray Mini-Merchandisers are designed for
maximum durability and performance, with minimum
maintenance.
WARNING
To avoid any injury, turn the power switch off,
unplug the unit from the power source and allow to
cool before performing any maintenance.
CAUTION
Glo-Ray Mini-Merchandisers are not waterproof.
DO NOT submerge in water. Do not operate if unit
has been submerged in water.
To preserve the finish of the Glo-Ray Mini-Merchandiser,
it is recommended that the surfaces be wiped daily with
a damp cloth. Food pans should be removed and
washed. Stubborn stains may be removed with a good
non-abrasive cleaner. Stainless steel surfaces can be
cleaned with a stainless steel cleaner. Hard to reach areas
should be cleaned with a small brush and mild soap.
CAUTION
Abrasive cleaners could scratch the finish of your
Glo-Ray Mini-Merchandiser.
Clean acrylic surfaces with a common glass cleaner and
nonabrasive paper toweling or soft cloth.
LIGHT BULB REPLACEMENT
The display lights are shatter-resistant, incandescent
light bulbs which illuminate the warming area. These
bulbs have a special coating to guard against injury and
food contamination in the event of breakage.
1. To replace a light bulb, disconnect the power supply
from the unit and wait until the unit has cooled.
2. Light bulbs have a threaded base. Unscrew the light
bulb from the unit and replace it with a new special-
ly coated incandescent light bulb.
NOTE: Hatco shatter-resistant light bulbs meet N.S.F.
standards for food holding and display areas. For 120
Volt, 60 Watt applications, use Hatco part #02.30.043.00.
For 220 and 240 Volt, 60 Watt applications, use Hatco
part #02.30.058.00.
WARNING
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas, must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
ACCESSORIES
INFINITE CONTROL
(GRDW-2 only)
The infinite control allows the operator to manually
adjust the upper heat output from full wattage down to
any desired level.
PANS & TRIVETS
Stainless steel food holding pans are available in either
2-1/2" or 4" (6 or 10 cm) depths. These pans are offered
in full size, half size or third size. Optional wire trivets
prevent foods from touching pan bottom.