User Guide

WARNINGS
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
CAUTIONS
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to
avoid injury.
Locate the unit at the proper counter height, in
an area that is convenient for use. The location
should be level to prevent the unit or its contents
from accidentally falling, and strong enough to
support the weight of the unit and food.
The National Sanitation Foundation (NSF)
requires that GR2SD Series units over 36"
(91 cm) in length or weighing more than 80 lbs.
(36 kg) to be either sealed or raised on the
installation surface. If this unit cannot be sealed
at the point of use, 4" (10 cm) legs are included
to allow for proper cleaning access below unit.
See Hatco ACCESSORIES for installation
instructions.
CAUTIONS
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it
susceptible to soil accumulation.
Only soft cleaning cloths should be used to clean
breath protector(s). Breath protector(s) are
made of shatterproof polycarbonate and will
scratch if proper care is not taken.
IMPORTANT SAFETY INSTRUCTIONS
1
WARNINGS
Plug cabinet into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to determine
the proper voltage and size and install the proper
electrical outlet.
Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water.
To avoid any injury, turn the power switch off at
the fuse disconnect switch/circuit breaker or
unplug the unit from the power source and allow
to cool completely before performing any
maintenance or cleaning.
To prevent electric shock, always unplug the unit
before performing cleaning or maintenance.
Do not place food product directly onto hardcoat
surface. Food product must be wrapped, boxed or
on a food pan.
For safe and proper operation, the unit must be
located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion
could occur.
To avoid electric shock or personal injury, do not
steam clean or use excessive water on the unit.
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax [phone] or International
fax [phone].
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
Form No. GR2SDM-0102
IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.