User Guide

CAUTIONS
1. Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
2. Locate the unit at the proper counter height, in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from accidentally falling, and strong
enough to support the weight of the unit and
food.
3. Do not submerse unit in water.
4. Do not add a decorative soffit to hide a
pass-through mounted Glo-Ray Foodwarmer.
5. All electrical connections must be in accordance
with local electrical codes and any other
applicable codes. Connections should be made
by a qualified, licensed electrician.
6. Foodwarmers with incandescent lights that
require a circuit breaker larger than 20 amps
must have a separate circuit breaker for the
incandescent lights that is 20 amps or less.
CAUTIONS
1. Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it
susceptible to soil accumulation.
2. The remote control box (RMB) must be
installed outside of the heat zone.
3. Damage to countertop material such as Corian
®
and similar products caused by heat generated
from Hatco equipment is not covered under the
Hatco warranty. Contact the manufacturer of
the base material for application information.
IMPORTANT SAFETY INSTRUCTIONS
1
WARNINGS
1. To avoid any injury, turn the power off to the
unit and allow to cool before performing any
maintenance.
2. Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas must be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
3. For safe and proper operation, the unit must be
located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could
occur.
4. Do not install standard wattage foodwarmer
(GR2A & GR2AL Series) less than 17" (43 cm)
above nonmetallic surface. Do not install high
wattage foodwarmer (GR2AH Series) less than
20" (51 cm) above nonmetallic surface. Do not
install high wattage foodwarmer (GR2AHL
Series) less than 22" (56 cm) above nonmetallic
surface. Do not install standard wattage, dual
foodwarmer (GR2A-XXD Series) less than 27"
(69 cm) above nonmetallic surface. Do not
install high wattage, dual foodwarmer
(GR2AH-XXD & GR2AHL-XXD Series) less
than 32" (81 cm) above nonmetallic surface.
Install all Designer foodwarmers so there is a
minimum distance of 6" (15 cm) from a
nonmetallic wall or adjacent surface.
5. If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at
800-558-0607 or 414-671-6350;
fax [phone] or International fax
414-671-3976.
6. This product has no “user” serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when service
is required.
7. Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in
electrical shock or burn.
Form No. GR2AM-0601
IMPORTANT! Read the following important safety instructions to avoid personal injury or death,
and to avoid damage to the equipment or property.