User Guide

MAINTENANCE
Form No. DHLM-0105
10
OPERATION
Place the ON/OFF toggle switch in the ON position.
The heat bulb will light when the unit is energized.
WARNING
Decorative Heat Lamps are not waterproof.
To avoid electrical shock or personal injury DO
NOT submerge in water. Do not operate if it has
been submerged in water.
CAUTION
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
Figure 9. Switches
GENERAL
The Hatco Decorative Heat Lamps are designed
for maximum durability and performance,
with minimum maintenance.
CLEANING
To preserve the finish of the Decorative Heat Lamps
it is recommended that the lamp shade surface be
wiped daily with a soft damp cloth. Stubborn stains
can be removed with a mild non-abrasive cleaner.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
WARNING
To avoid any injury or electrical shock, turn
the power switch and the fuse disconnect
switch/circuit breaker off. Allow to cool
completely before performing any maintenance
or cleaning.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
Decorative Heat Lamp, marring its appearance
and making it susceptible to dirt accumulation.
HEAT BULB REPLACEMENT
Each standard wattage Decorative Heat Lamp (DL)
is supplied with one clear, uncoated infrared heat
bulb rated at 250 watts. Each high wattage
Decorative Heat Lamp (DLH) is supplied with one
clear, uncoated infrared heat bulb rated at 375
watts. 250 watt bulbs may also be used in DLH
units.
WARNING
For safe and proper operation, do not install a
375 watt bulb into a DL standard watt lamp.
1. To replace a bulb, place the switch in the OFF
position and allow the bulb to cool completely.
2. Bulbs have a threaded base. Unscrew the heat
bulb counter clockwise from the unit and replace
with a new bulb.