Instruction Manual

Form No. EBOOSTERM-0321
16
English
INSTALLATION
Temperature/
Pressure Gauge
Pressure Reducing Valve
with High Pressure By-pass
(20 psi [138 kPa] flow
pressure maximum)
Temperature/
Pressure Gauge
Shock Absorber
for water hammer.†
Discharge from T/P Valve.
Air gap must comply
with plumbing code.
3/4″ Gate or
Ball Valve‡
Blended Phosphate Water
Treatment System†
Back
Pressure
Relief Valve†
Inlet
Temperature/Pressure
Relief Valve, 150 PSI/210°F
(1034 kPa/99°C)
Flow
Restrictor†
Floor Drain‡
Drain Valve‡
NOTE: Centerline of booster “T” fitting must
not extend closer than 102 mm (4″) to the floor.
Copper Water Inlet
from primary
water heater.
Copper Outlet
to Dishwasher.
Temperature/
Pressure Gauge
Temperature/
Pressure Gauge
Floor Drain‡
Shock Absorber
for water hammer.†
Discharge from T/P Valve.
Air gap must comply
with plumbing code.
3/4″ Gate or
Ball Valve‡
Blended Phosphate Water
Treatment System†
Outlet
Back
Pressure
Relief Valve†
Inlet
Drain Valve‡
Pressure Reducing Valve
with High Pressure By-pass
(20 psi [138 kPa] flow
pressure maximum)
Temperature/Pressure
Relief Valve, 150 PSI/210°F
(1034 kPa/99°C)
Copper Water Inlet
from primary
water heater.
Copper Outlet
to Dishwasher.
Mini-Compact Models
Compact Series
Plumbing Connections
WARNING
Valves, gauges, and unions must be installed per diagram
to ensure proper operation, servicing, and warranty
coverage.
†
Not supplied, but is available as an option/accessory.
‡
Not supplied with booster heater.