User manual

X1D II 50C USER GUIDE www.hasselblad.com
63
FUNCTIONS
Contents
3
3
580
+1.0 EV
Exposure Bracketing
3
Exposing
Finish Exposure
A
B
EXPOSURE BRACKETING OPERATION
An active and pending Exposure Bracketing function, is
indicated both on the Control Screen and in Live View.
The Control Screen and Live View will show the Bracketing
Icon and the number of captures in the sequence. To see all
settings, tap the Interval Icon to show the settings screen as
described on the previous page.
In the example to the right, the Exposure Bracketing sequence
will use 3 images.
To start the sequence, press the shutter release. If you have
set an initial delay to prevent camera shake, the camera will
rstwaitthepre-setnumberofsecondsshowingablack
screen with a count-down timer, and then start the Interval
sequence.
During the Exposure Bracketing sequence, the rear screen
and EVF will show an information overlay, as shown in (A) .
To exit from the sequence before it has been completed,
press the Cross Button.
After a capture, the last image will show up on the rear screen
LONG EXPOSURE SCREEN
If the Shutter Speed is 1 second or longer, the Long Exposure
Screen (B) will be shown during the exposure. After about
5 seconds the display will be turned off and the camera will
enter a power-save mode. You can re-activate the screen to
monitor exposure progress by moving your hand in front of
the EVF without touching the camera.
Note!
Exposure Bracketing is not supported in Phocus Mobile 2 or
when tethered to Phocus. For tethered operation, use the
Capture Sequencer function in Phocus.
Note!
Light measurement, focusing and Auto White Balance are
performedbeforetherstexposureandisappliedtoall
images in the sequence.
Control Screen
Live View
Screen during Bracketing operation
Screen when shutter speed is 1 sec or longer.