User manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Lenses
- 4 Functions
- 4.1 Parts, Components, Buttons and Controls
- 4.2 Grip Buttons and Controls
- 4.3 Camera Body Buttons and Controls
- 4.4 Mode Dial
- 4.5 Exposure Program Modes
- 4.6 The X1D II Interaction Displays
- 4.7 Touch Display Navigation
- 4.8 Navigating the Menus
- 4.9 Touch Display Main Menu
- 4.10 Control Screen
- Locked Exposure Parameters on the Control Screen
- Settings on the Control Screen
- Self Timer settings
- Interval settings
- Interval Operation
- Exposure Bracketing settings
- Exposure Bracketing Operation
- Long Exposure Screen
- Focus Bracketing
- Focus Bracketing settings
- Focus Bracketing Operation
- Step Size
- DoF and Step size visualized
- Examples
- Fixed Exposure Compensation Setting
- Exposure Compensation / Quick Adjust
- Light Meter Mode
- 4.11 Video Recording
- 4.12 Connector Ports
- 4.13 Memory Cards
- 4.14 Stop Down Button
- 4.15 Live View indications
- 4.16 Focusing
- 4.17 Move Autofocus Point
- 4.18 Resize Autofocus Point
- 4.19 Move Autofocus Point using Touchpad
- 4.20 Change Settings on the Grip
- 4.21 Browsing, Preview and Histogram
- 4.22 Image Rating
- 5 Settings
- 6 Phocus
- 7 Accessories
- 8 Appendix
X1D II 50C USER GUIDE www.hasselblad.com
61
FUNCTIONS
Contents
A B
C
D
INTERVAL OPERATION
An active and pending Interval Timer, is indicated both on the
Control Screen and in Live View.
The Control Screen shows the Interval Icon
(A)
and the
Interval Time
(B)
. To see all settings, tap the Interval Icon to
show the settings screen as described on the previous page.
Live View and preview Screens show the same information
with the addition of remaining number of captures
(C)
and
(D)
.
To start the sequence, press the shutter release. If you have
set an initial delay to prevent camera shake, the camera will
rstwaitthepre-setnumberofsecondsshowingablack
screen with a count-down timer, and then start the Interval
sequence.
After a capture, the image will show up on the rear screen,
together with the Interval information.
To end the sequence before all captures have been made,
press
Exit
(the Star Button).
Note!
Live View is turned off during an Interval sequence.
Note!
The preview can be turned off in the "
General Settings >
Preview > Rear Screen
" setting.
Note!
Interval is not supported in Phocus Mobile 2 or when tethered
to Phocus. For tethered operation, use the Capture Sequenc-
er function in Phocus.
Note!
During a running Interval Sequence, you can press the Menu
Button to activate the Control Screen to check current status.
Control Screen
Preview Screen after a capture
Live View