User manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Lenses
- 4 Functions
- 4.1 Parts, Components, Buttons and Controls
- 4.2 Grip Buttons and Controls
- 4.3 Camera Body Buttons and Controls
- 4.4 Mode Dial
- 4.5 Exposure Program Modes
- 4.6 The X1D II Interaction Displays
- 4.7 Touch Display Navigation
- 4.8 Navigating the Menus
- 4.9 Touch Display Main Menu
- 4.10 Control Screen
- Locked Exposure Parameters on the Control Screen
- Settings on the Control Screen
- Self Timer settings
- Interval settings
- Interval Operation
- Exposure Bracketing settings
- Exposure Bracketing Operation
- Long Exposure Screen
- Focus Bracketing
- Focus Bracketing settings
- Focus Bracketing Operation
- Step Size
- DoF and Step size visualized
- Examples
- Fixed Exposure Compensation Setting
- Exposure Compensation / Quick Adjust
- Light Meter Mode
- 4.11 Video Recording
- 4.12 Connector Ports
- 4.13 Memory Cards
- 4.14 Stop Down Button
- 4.15 Live View indications
- 4.16 Focusing
- 4.17 Move Autofocus Point
- 4.18 Resize Autofocus Point
- 4.19 Move Autofocus Point using Touchpad
- 4.20 Change Settings on the Grip
- 4.21 Browsing, Preview and Histogram
- 4.22 Image Rating
- 5 Settings
- 6 Phocus
- 7 Accessories
- 8 Appendix
X1D II 50C USER GUIDE www.hasselblad.com
54
FUNCTIONS
Contents
A
1
B
2
C
3
D
4
5
SETTINGS ON THE CONTROL SCREEN
Set White balance from image (Picker)
Tap the white balance icon on the control screen to bring up
the settings screen. Tap the Picker icon (
A
).
The screen will show the last captured image with a white
balance picker tool (
B
).
If the center of the image is not neutral, move the picker tool
by touching anywhere inside the circle (
1
) and sliding so that
the measuring area (
2
) falls over a neutral area (
C
). The status
bar will show the actual values for Temp and Tint. To accept
these values, press the rectangle button (
4
). To exit without
saving the values, press the cross button (
5
).
The control screen (
D
) will now show the new value for Temp
and it will be used together with Tint for following images.
1 Active area for moving the
tool by touch.
2 Active area for calculating
Temperature and Tint.
Note!
You can change to another image by turning the front scroll
wheel or by swiping the image outside of the picker tool area.
Note!
Youcanne-tunethepositionbytappinginsidethecircle.
E.g., if you tap at point (
3
), the picker will move a small
increment down.
Note!
To simplify using the Picker tool, you can add it as a short-cut
to the main menu screen or program one of the custom
buttons as described on 126.
This chapter continues on the next page.