User manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Lenses
- 4 Functions
- 4.1 Parts, Components, Buttons and Controls
- 4.2 Grip Buttons and Controls
- 4.3 Camera Body Buttons and Controls
- 4.4 Mode Dial
- 4.5 Exposure Program Modes
- 4.6 The X1D II Interaction Displays
- 4.7 Touch Display Navigation
- 4.8 Navigating the Menus
- 4.9 Touch Display Main Menu
- 4.10 Control Screen
- Locked Exposure Parameters on the Control Screen
- Settings on the Control Screen
- Self Timer settings
- Interval settings
- Interval Operation
- Exposure Bracketing settings
- Exposure Bracketing Operation
- Long Exposure Screen
- Focus Bracketing
- Focus Bracketing settings
- Focus Bracketing Operation
- Step Size
- DoF and Step size visualized
- Examples
- Fixed Exposure Compensation Setting
- Exposure Compensation / Quick Adjust
- Light Meter Mode
- 4.11 Video Recording
- 4.12 Connector Ports
- 4.13 Memory Cards
- 4.14 Stop Down Button
- 4.15 Live View indications
- 4.16 Focusing
- 4.17 Move Autofocus Point
- 4.18 Resize Autofocus Point
- 4.19 Move Autofocus Point using Touchpad
- 4.20 Change Settings on the Grip
- 4.21 Browsing, Preview and Histogram
- 4.22 Image Rating
- 5 Settings
- 6 Phocus
- 7 Accessories
- 8 Appendix
X1D II 50C USER GUIDE www.hasselblad.com
INTRODUCTION
Contents
15
4
1
2
3
5
1.10 BATTERY
Rechargeable Battery
The environmentally approved Battery is the standard Power
Source for the X1D II Camera (1). It is advisable to keep an
extra fully recharged battery on hand. As is the case with
most batteries, problems might be encountered when used in
very low temperatures. In this situation it is advisable to keep
the reserve battery inside a warm pocket, for example, to
maintain it near body temperature.
How to remove a Battery
1 Remove the battery
(1)
from the camera
by rotating the
battery lever
(2)
.
2 The battery will move up a bit
(3)
automatically.
3 Then press the battery in a bit but not all the way, to
release it from the camera completely.
4 Remove the battery
(4)
.
5 The īrst time you use the camera after unboxing, please
remove the plastic tab
(5)
on the battery before re-insert-
ing.
How to mount a Battery
1 Align the battery with the contacts facing the lens and
push it
into the battery compartment until it locks into
place.
Note!
When the battery is inserted, the rear Status LED will show a
blink sequence once to indicate the current battery charge
level. See next page for details.
Note!
If the camera doesnāt start up when a new battery is inserted,
connect the camera via USB to a computer or a charger.
You can also remove the battery and place it in the optional
Charging Hub accessory.