User manual
INTEGRAL FLASH
The integral ash unit (A) features the following specications:
Guide number: 12
Coverage: 56º horizontal, 44º vertical
Maximum light fall-off at side centres: - 1EV (50%)
Colour temperature (full ash): 5,000 – 5,600 ºK
The ash unit is automatically activated when it is in the
operative position and deactivated when returned to its stored
position.
The green LED ash symbol blinks in the viewnder when the
ash unit is charging and remains stationary when fully charged.
The ash output can also be adjusted for optimum light balance
in ll ash situations.
How to use the integral ash
1 Slide the Integral Flash Release (B) backwards in the
direction of the ash symbol.
2 On the Camera Sensor Unit Display select Camera Settings
> Exposure and scroll down to Flash.
3 Choose between Normal or Rear sync.
4 Set Low Flash Warning to On or Off.
5 Exit the Main Menu to Save and make an exposure.
6 If the settings were incorrect to match the output of the ash
unit, the viewnder display shows a red triangle alongside
a ashing green Flash LED Symbol plus a warning message
"Low ash". The grip display will also show a warning
message "Low ash".
Conventional measures should then be taken to correct
the situation. Move closer to the main subject, use a larger
aperture setting or use a higher ISO setting.
WARNING!
Do not use the integral ash (A) together when another external
TTL ash unit is connected (and used in TTL or A mode).
Note!
For full coverage with the integral ash, use 80mm or longer
lenses (without a lens shade).
H6D www.hasselblad.com
USER GUIDE
To Use
85
Table of Content
A Integral ash
B Integral ash release
Flash LED Symbol
A
B