User manual

3.23 ACCESSORY CONNECTION
There are two accessory retaining screw threads (M5) as
well as a databus connector on the left hand side of the camera
body, protected beneath a cover (A).
How to remove the Databus Connector cover
1 Remove the cover by rst lifting the left hand edge (A) a
little.
2 Slide the cover to the left (B).
3 Lift the front edge of the cover rst (A).
4 Remove the cover.
5 Attach the Databus cable.
3.24 PC FLASH CONNECTOR
A PC connector for non TTL ash synchronisation (3) is located
on the left side of the body. It is protected by a captive rubber
plug.
A
B
3
H6D www.hasselblad.com
USER GUIDE
Overview
44
Table of Content