User manual

3.16 BATTERY AND BATTERY GRIP

Rechargeable battery grip

The environmentally approved Battery grip Li-ion (3043357)

is the standard power source for the H6D camera. The H6D

requires a power supply for all actions as there is no mechanical

reserve facility. It is therefore advisable to keep a spare

rechargeable battery grip at hand. As is the case with most

batteries, problems might be encountered when used in very

low temperatures. In this situation it is advisable to keep the

spare battery in an inside pocket, for example, to keep it at body

temperature.

Remove a battery

1 Remove the battery from the camera by pressing the battery

holder button (A) and simultaneously swinging the battery

holder retaining lever (B) down until it stops.

2 Pull the battery downwards (C).

Attach a battery

1 To t, hold the battery at against the camera body and align

the two upper lugs with the slot.

2 Slide the battery back into position.

3 Rotate the battery holder retaining lever (B) back until it

clicks into place.

Store a battery

If you intend to store the battery separate from the camera,

ensure the safety cover is mounted over the electric connections

on the battery to prevent short circuits. It snaps into place and

is removed by pulling outwards and upwards on the locking clip.

Connect battery to charger

1 Connect the charger plug to the plug connector on the inside

of the battery (D).

2 Connect the charger to the wall socket.

Note!

Only the supplied 3200 mAh battery should be used. The older

type with 2900 mAh can be used, but with limited capacity. The

old 1850 mAh battery should not be used.

See next page for more in depth information.

H6D www.hasselblad.com

USER GUIDE

Overview

Table of Content