User Guide

77
This manual is a provisional version only.
4. Finally check if the IR filter has been properly cleaned either by visual inspection or
by mounting the sensor unit to the camera and making a shot. If further cleaning is
needed, repeat cleaning procedure.
Cleaning with an E-Wipe
E-wipes are individually packed wet tissues.
1. Tear at the notch to break seal.
2. Remove e-wipe from its packaging and continue without delay.
3. Fold the tissue to match the width of the IR filter.
4. Apply firm pressure using two or three fingers at the edge of the wipe to ensure an
even, firm contact with filter surface. Wipe the surface in one unbroken motion.
 Note! Do not use same side of the e-wipe twice as you will be likely to reapply any particles
removed in the first pass.
5. Finally check if the IR filter has been properly cleaned either by visual inspection or
by mounting the sensor unit to the camera and making a shot. If further cleaning is
needed, repeat cleaning procedure.
Cleaning the housings
If the camera becomes dirty, clean it with a so, clean cloth lightly moistened with water
only. Do not use any other solvents and do not allow water to get.