User manual

CFV 50c

ELX

For use with 500EL/ELM and 500/553ELX models:

• Make an ELX setting.

• The Exposure Cable EL (supplied) should be connected.

• Rapid sequence shots are not possible.

• Use a Battery Adapter (optional accessory 3054668) to provide the necesssary extension be-

yond the motor housing of the EL models for battery attachment. It is attached to the CFV-50c

in the same manner as a battery, and the battery itself is then attached to the adapter as in the

illustration.

All Hasselblad EL models except ELD

Exposure Cable EL

Pinhole

For use with lenses/cameras with no shutter. Intended primarily for use in a studio environment where complete darkness can

be achieved and exposures made accordingly, for ‘light painting’ etc. In this mode the CFV-50c uses the exposure time (as well

as other required stages in a capture sequence) set in the Capture Sequence dialog. The CFV-50c can be triggered from Phocus

(see later section for full description of Capture Sequence settings procedure).

Flash sync

For use with un-modiﬁed 200 series models (together with C-lenses in C-mode),an ArcBody, a FlexBody or view

cameras ﬁtted with a Hasselblad adapter.

• Make a Flash sync setting.

• A Flash sync input cable should be used.

• All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.

• Do not use a winder at rapid sequence setting.

SWC

For use with the SWC/M, 903 SWC and 905 SWC models.

• Make an SWC setting.

PLEASE NOTE: Due to the mechanical design of the SWC, pressing the exposure release button too slowly may cause a faulty capture with a

magenta cast. Either press the button much more distinctly or alternatively change the setting from SWC to Flash sync and use the Flash

input sync cable to connect the lens to the CFV-50c.

Use a Battery Adapter (optional accessory 3054668) to provide the necesssary extension beyond the tripod shoe. It is attached to the

CFV-50c in the same manner as a battery, and the battery itself is then attached to the adapter as in the illustration.

200

For use with modiﬁed 202, 203 and 205 models together with F-lenses / CF-lenses in F-mode. (Only these three mod-

els can be modiﬁed for cable-free compatibility with the CFV-50c. Please contact your Hasselblad dealer for further informa-

tion)

• Make a 200 setting.

• A Flash sync input cable should not be used.

• All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.

• Do not use a winder at rapid sequence setting.

500

For use with 500C/CM, 501C/CM and 503 CX/CXi/CW/CWD models.

• Make a 500 setting.