- HASSELBLAD User's Manual CF22 CF39

2. Fold the tissue several times to match the width of the IR lter—you might use two

or three tissues at a time if necessary (to give you a better grip). Be sure to fold the

paper so that the coated glossy side faces outwards—do not use the other side, as it

can do more harm than good!

3. Gently place the folded tissue onto the edge of the lter using two or three ngers.

Be sure to wipe the entire surface evenly. Sweep the lter only once. Do not wipe the

same area twice with the same tissue as you might reapply dirt removed in the rst

sweep.

4. Finally check if the IR lter has been properly cleaned either by visual inspection or

by mounting the digital back to the camera and making a shot. If further cleaning is

needed, repeat cleaning procedure.

Cleaning with an E-Wipe

E-wipes are individually packed wet tissues.

1. Tear at the notch to break seal.

2. Remove the e-wipe from its packaging and continue without delay.

3. Fold the tissue to match the width of the IR lter.

4. Apply rm pressure using two or three ngers at the edge of the wipe to ensure an

even, rm contact with lter surface. Wipe the surface in one unbroken motion.



Note! Do not use same side of the e-wipe twice as you will be likely to reapply any

particles removed in the rst sweep.

5. Finally check if the IR lter has been properly cleaned either by visual inspection or

by mounting the digital back to the camera and making a shot. If further cleaning is

needed, repeat cleaning procedure.

Cleaning the housings

If the back becomes dirty do not use any other solvents. Clean it with a so, clean cloth

lightly moistened with water only. Do not allow water to enter any sockets or open-

ings.